All American Products Co.

TOOLING COMPONENTS

BALL LOCK MOUNTING SYSTEMS

Note:
Installed bushings should be approximately .012" below subplate surface.

To alleviate the possibility of binding the shank in the bore,
the maximum interference fit between bore and bushing O.D.
should not exceed .0005".

BACK MOUNT RECEIVER BUSHING INSTALLATION DIMENSIONS
SHANK DIA. (MM)	BACK MOUNT P/N	ACTUAL O.D. +.0000 -.0004 (A)	DEPTH +.000 -.002 (B)	C-BORE ±.006 (C)	MIN. SUBPLATE THICKNESS (D)
13	610-14	0.7870	.277	1.000	3/4
16	610-17	0.8760	.285	1.155	3/4
20	610-21	1.0950	.345	1.280	1-1/8
25	610-26	1.3763	.416	1.593	1-1/4
30	610-31	1.6264	.432	1.906	1-1/4
35	610-36	1.8764	.493	2.155	1-3/8
50	610-51	2.6269	.621	2.988	1-13/16

Drill Bushings Tooling Components Toggle Clamps
Back Receive Literature Home Page

All American Products Co.
1135 Aviation Pl., P.O. BOX 190, San Fernando, CA 91340
Tel.: (818) 361-0059, Fax: (818) 898-2236
E-Mail Address: sales@allamericanproducts.com