All American Products Co.

Back

TOOLING COMPONENTS
INSERT INSTALLATION

E-Z LOK external threads are standard size and pitch to permit use of standard drills and taps. No special top sizes or installation tools are required.
Installation is easy as 1-2-3
Use E-Z LOK Thread Inserts for: -Jigs and Fixtures
-Bolster Plates
-Dies
-Machine Tools
-Metal Patterns
-Farm Machinery
-Engine Blocks
-Parts Salvage
-Stripped Threads in any material

 
Power drive tools are available for volume installation...See insert
tables for catalog numbers and sizes.
Automatic self-locking external thread with pre-applied,
use activated Loctite®
E-Z LOK inserts will not back out or vibrate loose.
Immediately on installation, micro-encapsulated Loctite(r) begins to set and the newly
installed insert can be fastened to within minutes. The adhesive continues to cure overnight
until completely set.
The adhesive seals against liquids and gases to pressures of 6,000 psi and bonds to virtually all metals
EASY REMOVAL: Use a standard screw and bolt extractor to back out a damaged insert and then replace it
with a new insert.

Removal is simply a matter of overcoming the resistance to torque-out which has been produced by the
thread locking material.

Loctite Registed Trademark.
   

  Drill Bushings  Tooling Components  Toggle Clamps 
Back  Receive Literature  Home Page

All American Products Co.
 1135 Aviation Pl., P.O. BOX 190, San Fernando, CA 91340
Tel.: (818) 361-0059, Fax: (818) 898-2236
E-Mail Address: sales@allamericanproducts.com

Copyright (c)1996-2003 All American Products Co. All Rights Reserved.